Recent content by Ducktape

Top side of picture goes in towards the outer CV, thus circlip is on the side without indents...

Goes on half-way either end... Just want to make double sure before I use a bit of persuasion to fully seat it....aka rubber mullet...

Hi Guys, just busy replacing my CV as the outer is knackered... Can anyone tell me which way this inner CV goes back on the shaft? Is that top ridge in this picture towards the top (circlip side) or bottom (outer CV side)...? I just cant remember from taking it off the axle... Thanks, (and...

Thanks Chris, you would'nt happen to have a few pic's of the process do you...? Everytime I've had to work on the CV's in the past I've removed the 4 bolts on the lower wishbone and tilt the strut out of the way which saves me to remove batteries, etc. It was a bit of a pain with those long...

"i put the stop leak in mine amd that has worked for me. " Where did you add it? Assuming to the frond diff oil? As a temp measure...

Anyone have any experience on manual gearboxes..? My '02 Colorado GX (1KD-FTV) with manual box has started to "grind" when shifting to second gear out of the blue. Mr. T replaced the clutch (+ release bearing, etc.) about 5000miles ago with a genuine part so the clutch is working fine in my...

Oil leak on front diff Will it be the same leaking seals as mine currently??? Would any of you that has changed these oil seals mind to share how this is to be done and how much blood/sweat/beer is required or any special tools, etc?

Ha-ha, caught out...:doh: This is what happens when you're too lazy to take your camera and go take a picture of your own vehicle thus rather 'borrow' one... I guess all I can say is Thanks! (PS: I used to have a Suzuki SV650s, Suzuki Bandit 650 & Kawasaki ER500 before we left London, if that...

Picture To clarify which "seal" I'm reffering to... When you look at the transfer case from the rear you will see the main cover with about 13 bolts that secure it in place (the seal is for this cover) and the rear prop shaft attaches at the top shaft which have another cover. I noticed a...