Don't like the adverts? Click here to remove them
Jon Mac's latest activity
-
Jon Mac replied to the thread 200 series parts.We've finally traced the problem, located the TURBO MOTOR DRIVER which is under a headlamp unit. Its completely corroded and the circuit... -
Jon Mac replied to the thread 200 series parts.Update, turbos fitted and engine reinstalled however one of the fault codes hasn't cleared. My mechanic has been exploring potential...
-
If the person working on the car is passionate, you should be fine. Please update how it’s come out
-
Jon Mac replied to the thread 200 series parts.Struggling to locate whereabouts of the boost control module to check and test the wiring as it’s doesn’t seem to be as per the wiring...
-
Jon Mac replied to the thread 200 series parts.I think but not sure that actuator can be changed from in wheel arch, but I understand from my mechanic that the engine is a tight...
-
Jon Mac replied to the thread 200 series parts.Further update... engine back with two new OEM turbos fitted, engine running however frustratingly the P004C fault still present. My...
-
Jon Mac replied to the thread Seat Covers Recommendations.I have Sand Storm Kenya.
-
Jon Mac replied to the thread 200 series parts.Upon investigation the actuator sized due to turbo failure. I have ordered 2x OEM turbos from Turbo Diesel in Suffolk, and the garage...
-
Jon Mac replied to the thread 200 series parts.Hi Brett. I did consider but have decided since there is so much labour going into the work I'll put new OEM parts on. John
-
Jon Mac replied to the thread 200 series parts.Hi Brett, Thanks, will price the parts up with them tomorrow. John
-
I am into expensive territory with my 4.5 VDJ200 and would welcome any advice, specifically around parts. Engine warning light and limp...
