Don't like the adverts?  Click here to remove them

Recent content by l3n0x

  1. L

    1HD-FTE Limp mode - TPS issue?

    Thank you very much for the great idea!:)
  2. L

    Oil brand change

    Okay, so I went with Motul 8100 X-Max 0w40 at the end. It doesn't have the CF specification unfortunatelly (only SN), but has ACEA A3/B4. Every other option - available in my country - was worse, so.. If my engine explodes, it explodes.. I've been researching this topic for months, and couldn't...
  3. L

    Oil brand change

    Thank you for your detailed comments! I could get Motul oils (Xmax 0w40 for example), but Ravennol is a bit pricey here (around 18 USD / liter) at the only place I could get it from:( I'll try to find a german shop that ships it to Hungary maybe. Thanks once again
  4. L

    Oil brand change

    I kind of agree. The only issue is that here we have -10 in the winter and 40 in the summer. And I'm afraid that the 15w40 would do damage in the winter. 10w40 perhaps?
  5. L

    Oil brand change

    That's my problem. The books says 10w30, but that's not sold in my country.
  6. L

    Oil brand change

    Somebody please?
  7. L

    1HD-FTE Limp mode - TPS issue?

    Thanks for all the responses. The issue didn't reaper yet, so I'm still hesitant about buying another accelerator assembly (they're not very cheap). Right now I'm hoping it was just a particle of dust sticked to one of the sensors/switches that cleared itself:)
  8. L

    Error code 19(4) for LC100

    How long did the fix last?
  9. L

    1HD-FTE Limp mode - TPS issue?

    Hi! My 2000 LC has developed an issue. Today after the walking the dogs & going home it throw a check engine light and went into limp mode. I've tried to shut down / restart the car, but the issue was still there. When I got home I've read the codes with TS, and this is what came up: After...
  10. 19(2)_error.jpg

    19(2)_error.jpg

  11. L

    Injector leaking

    Hello! I've cleaned the intake manifold & replaced its gaskets some 10k kms ago. During that process I've also replaced al injector pipes and pipe clamps for new ones. Now nr3 injector has a light oil mist on the pipe right at the injector. I was wondering if it was worth touching it, and if...
  12. L

    Oil brand change

    Hi All! For the past 8k km's I was using Castrol Edge 5w30 C3 in the 100 (1HD-FTE). I liked it, but perhaps there is better, especially for the summer months as winters don't really go below -10 anymore here:) I feel like it gets a bit too thin in the summer heat. Was wondering if a 0w40 would...
  13. L

    Can the HDJ100 do 130kmh all day long?

    So I've been using my cruiser @100kmh, because it drives well & I get good mileage. But it's a PITA on long (5-600km) highway trips. I've tried 130kmh, but it felt unstable & the engine was a bit on the loud side. The car has around 500k kms in it. Is it safe/possible/etc. to drive these at...
  14. L

    V-Belt tension - going in from above

    Haha:)) Yeah, I've also remember something about the IC pipes.. But then it's probably easier to drop the skid and crawl under:( Merry Xmas:)
  15. L

    V-Belt tension - going in from above

    Hello! 1hd-fte with aircon and viscous heater Is there a way to tighten the v-belt(s) (that runs the alternator) from above? I can do it from below, but I'm too lazy to pull the skid plate & lay under the car into the snow. And if there is, what's the trick to it? I just can't seem to get a...
Back
Top