Recent content by smartchap

No, the rear sensor switch and wiring is intact and ok till ECU. Can you link the sensor testing method you mentioned? I did search earlier but didnt find it or are you referring to feeling with fingers?

So I had a chance to spare some time to look around last weekend. I measured voltages and resistance on the normal two pin connector, the green one didnt read anything as it were a floating pin, no voltage or continuity to ground. The gray one was live wire powering the LED light. However, I did...

Sure. I'm aware of the potential bumper/sensors issue and believe most probably some sensors are shot as I get a long warning beep at startup which I'm trying to diagnose which requires this missing switch but I'm hopeful. Will give it a shot this weekend.

maybe, but I've got the itch to get it working :cool: Thank you for the offer. I'll try the DIY route and see how it goes.. If not will look for a backup.. Dont want to bother you with Int'l shipping

Thank you.. that's the one I was looking for.. from documentation, besides the two pin connector it should also have a ring terminal for grounding. I bought mine used and it had tpa800 already installed albeit with missing bits. This button is completely missing. the connector are left hanging...

I know its an old post but can someone please confirm wiring connections of front switch, the one with LED ( I mean inside the switch, which wires it shorts when button is pushed). Reason is mine is missing and I cannot find a replacement anywhere. It seems a simple enough switch without any...