Don't like the adverts?  Click here to remove them

Search results

  1. Jon Mac

    200 series parts

    We've finally traced the problem, located the TURBO MOTOR DRIVER which is under a headlamp unit. Its completely corroded and the circuit boards are badly corroded. Ordering a replacement from Part Souq and hopefully that'll be it sorted out, with two new turbos so should be full power, as is the...
  2. Jon Mac

    200 series parts

    Update, turbos fitted and engine reinstalled however one of the fault codes hasn't cleared. My mechanic has been exploring potential causes, and when he connected LH bank wiring to old RH bank turbo and actuator the fault then cleared. The original fault codes were both LH bank, one cleared but...
  3. Jon Mac

    200 series parts

    Struggling to locate whereabouts of the boost control module to check and test the wiring as it’s doesn’t seem to be as per the wiring diagram, a tech at Toyota is sending over a full engine wiring diagram. Does anyone have any knowledge of what to check for this fault including not obvious...
  4. Jon Mac

    200 series parts

    I think but not sure that actuator can be changed from in wheel arch, but I understand from my mechanic that the engine is a tight squeeze in the chassis so its engine out to change the turbos. The work on my 200 was done at Gwydir Garage in Llanrwst, they aren't Land Cruiser experts but the...
  5. Jon Mac

    200 series parts

    Further update... engine back with two new OEM turbos fitted, engine running however frustratingly the P004C fault still present. My mechanic has working through the electrics to identify if there's a problem there also. If any one knows anything about this fault or can offer any useful...
  6. Jon Mac

    Seat Covers Recommendations

    I have Sand Storm Kenya.
  7. Jon Mac

    200 series parts

    Upon investigation the actuator sized due to turbo failure. I have ordered 2x OEM turbos from Turbo Diesel in Suffolk, and the garage have ordered in the gaskets etc. and a new water pump as that is leaking, from Toyota. All in I estimate the total cost is going to be in the region of £5k...
  8. Jon Mac

    200 series parts

    Hi Brett. I did consider but have decided since there is so much labour going into the work I'll put new OEM parts on. John
  9. Jon Mac

    200 series parts

    Hi Brett, Thanks, will price the parts up with them tomorrow. John
  10. Jon Mac

    200 series parts

    I am into expensive territory with my 4.5 VDJ200 and would welcome any advice, specifically around parts. Engine warning light and limp mode on last month so I had a diagnosis at Toyota that indicated near side turbo, so left the vehicle at my local independent to assess further whilst I'm out...
  11. Jon Mac

    Ongoing AHC Problems

    Hi Raj. Fluid replacement and replaced both rear sensors with brackets. Considerably better than the weeks leading up to the failure but not massive improvement than earlier, perhaps slightly plusher and slightly more composed. I also replaced tyres around same time so that'll have contributed...
  12. Jon Mac

    What's going on with the tyre situation in UK?

    I've pushed the button on the Geolander A/T's. I'll just have to carry a second spare and a hi-lift if I go to Morocco.
  13. Jon Mac

    HELP! Wanted - Garage to do work on 120 - NE Wales (Wrexham, Shrop, Cheshire, etc.)

    I contacted West Coast a while back about replacing a corroded fuel filler neck on my 200, but they were too busy to fit the job in. I prefer to give business to independent family-owned businesses wherever possible but as they couldn't fit it in, I booked into my local Toyota dealership instead...
  14. Jon Mac

    What's going on with the tyre situation in UK?

    Hi Dave. Thanks for the input. The Geolanders are available in the correct specification size tyre for my wheels (285/50R20) which is preferable as I'm usually of the mindset that the men in lab coats at Toyota probably know more and better than I do. I've toyed with the idea of going with a...
  15. Jon Mac

    What's going on with the tyre situation in UK?

    My 200 is currently fitted with a full set of 285/50R20 NEXEN ROADIAN HP fitted when purchased and I think only suitable for road use in summer. With winter on the way I am thinking about ordering all-season tyres with light offroad / trail capability. Like many of us in UK most driving is on...
  16. Jon Mac

    Ongoing AHC Problems

    Good news. I'm out of country until end of next week, looking forward to getting back and test driving.
  17. Jon Mac

    Ongoing AHC Problems

    That's helpful thanks. The vehicle is 2010 with FTSH but no record of any susension related work in My Toyota, so I'll make a plan to replace springs, and be prepared for potential inevitable accumulator replacement at some point. I'm doing servicing at Toyota to keep up main dealer history, and...
  18. Jon Mac

    Ongoing AHC Problems

    D Did you notice much improvement in ride and / or handling after these were replaced? I'm not sure exactly how the system works in terms of whether it's either working or not, or whether its a gradually worsening until a point where it's given up and no longer working
  19. Jon Mac

    Ongoing AHC Problems

    Brief update on the 200. AHC fluid flush done but rear end down and system was showing LHR sensor fault, so part ordered and replaced, now the rear left levelling but not rear right which is also coming up as a sensor fault now so had to order that part too. A rather expensive month with the...
  20. WhatsApp Image 2023-11-13 at 10.04.25.jpeg

    WhatsApp Image 2023-11-13 at 10.04.25.jpeg

  21. Jon Mac

    Ongoing AHC Problems

    Really helpful thanks.
  22. Jon Mac

    Ongoing AHC Problems

    Yes had similar experience today across North Wales. It's now parked until going to the workshop.
  23. Jon Mac

    Ongoing AHC Problems

    I spoke with West Coast a while back and I think they mentioned Iron Man do a suspension kit that supersedes the AHC, but as long as it's repairable I would prefer to retain the AHC system.
  24. Jon Mac

    Ongoing AHC Problems

    eek. Where does one procure a replacement from if required or is it repairable?
  25. Jon Mac

    Ongoing AHC Problems

    Hi Raj. Thanks for the information, I'll have a closer look at the video when on my PC. Yes I can imagine the complexity of the vehicle is just too much hassle for many mechanics when they can make a living doing MOTs and changing exhausts etc. I use the local Toyota dealership for services, and...
  26. Jon Mac

    Ongoing AHC Problems

    Hi Brett, Thanks for getting back to me. I tried to get sight of the fluid level but its a black hole in there under that access cover. I've shared a load of info with the workshop including @PADDO method and what I think is the workshop manual for suspension that I've gathered from IH8MUD. Its...
  27. 105 GX

    105 GX

    105 GX
  28. IMG_1375.JPG

    IMG_1375.JPG

    105 GX - Ngong Hills
  29. Jon Mac

    Ongoing AHC Problems

    Hi Brett. Glad to hear you got it sorted. My V8 has developed a Check AHC warning when cornering and braking. Its booked into local indy who's quite knowledgeable with 4x4s and I've printed some materials to help him familiarise himself. I'm going to have it checked and a fluid flush (ordered...
  30. Jon Mac

    V8 new to me

    I bought a 2010 V8 earlier this year, a 130k miles one owner with full Toyota history. It's my second Land Cruiser after a fabulous 105 GX in Kenya. I live in Snowdonia now and it's used as a family wagon for general duties, holidays, ferrying kids about, carrying bikes, moving this and that...
  31. IMG_20231017_175241523_HDR.jpg

    IMG_20231017_175241523_HDR.jpg

Back
Top