Recent content by arnonmg

Francis, sorry for late response - i was not connected to the forum now its working... what i did back then was pushing the switch with my hand several times while blasting air on the microswitch all the time after several times the problem was gone for good - never happend again i stil have...

By adjusting the torsion bars you reduce or increase suspension pressure The height calibration done with height sensor and in some way can also influence on suspension pressures Look at the FMS for better understanding 2006 TLC 100 IL

Just for your info - the readings available : Pressure of accumulator Pressure at front right / left Pressure at rear Height front right / left Height rear Reading these parameters will help you to adjust / level car height, pressures, torsion bars The system carry part of the load and the...

The icarsoft can read the sensors - nothing more There are several test protocol that this box can do but I am not qualified for that With regard to the AHC. System - leveling, maintenance etc... There are few members here that help me solve my problems - suggest you speak with them first (uHu...

I didn't find the reason for any of the above issues and actually it's still happening from time to time - I figure out that there are few reasons - Leak somewhere or bed sealing High presser in the system Some defect part like valve or sphere or what ever I replaced the rear coil springs to...

No - I didn't check back then but when I had them side by side with the original ones they where shorter I can check the box or pull one of them out when I replace the rear shocks - one is bleeding I fly tonight for tow week - will get back to you when I have the info 2006 TLC 100 IL

I use the KTRS -79 at rear and they are shorter then original I didn't like it and I don't know if there's down side ... nowadays looking for beefier torsion bars - any idea? 2006 TLC 100 IL

Salty, My guess - fuel pump Mine has similar noise Once I open the cover while the engine was running and I could hear the noise clearly Unfortunately I broke the cover back then - be careful Back then I replaced the fuel filters and use add injectors cleaner to fuel Actually I used double...

I don't really know if there's an Oring on that shaft but it's look like something missing The lower ring on the shaft is metal ring Shaft diameter is 7.88mm and bearing diameter is 7.89mm so I assume that 0.01 means no wearing TLC 100 IL

The ugly part now - After taking apart the turbo I did few measurements- found nothing wrong!! I am not en expert and first time open a turbo but except the oil couldn't find problem in measures Any ideas or guideline will be appreciated ... TLC 100 IL