Rear bumper lights metal brackets - where to purchase

[MisterCruiser]

I could do with new bracket surrounds that fit around the lights in the rear bumper.

Roughtrax don't have them, I'm not sure of Millners fitment, they have them but I think I read they wern't a great fit. Anyone able to confirm?
Anyone know an approx price from Toyota? Or an alternative place to purchase them online?

Also, I could do with a replacement water trap for my fuel filter, the plastic piece that screws to the bottom of the fuel filter if anyone knows where I can source one other than Toyota dealer.

 

[jibberjabber]

I could do with new bracket surrounds that fit around the lights in the rear bumper.

Roughtrax don't have them, I'm not sure of Millners fitment, they have them but I think I read they wern't a great fit. Anyone able to confirm?
Anyone know an approx price from Toyota? Or an alternative place to purchase them online?

Also, I could do with a replacement water trap for my fuel filter, the plastic piece that screws to the bottom of the fuel filter if anyone knows where I can source one other than Toyota dealer.

Is this the bracket you need? and this for the fuel filter?

 

[MisterCruiser]

Cheers for the pics / part numbers.
Yeah they're the parts I'm looking for:

81556 RH
81566 LH

23303 = 2339064480

 

[Shayne]

The metal bracket inside the bumper doesn't do much of anything anyway a washer and nut will hold the lights in just the same i think the bracket was only added so there was somewhere tidy to slot the electrical connectors speeding things up on the production line .

Roughtrax lights are good , plenty sell cheaper that look identical until you try to fit them . I have two 90's the R/T rear bumper lights fit well and still work as they should maybe 8 years later . On my newer 90 the milners ones didn't fit well at all and i'm very glad i didn't chop out the bumper or anything to improve the fit because they had me blowing fuses within 12 months . I replaced them with Roughtrax lights .

 

[MisterCruiser]

These are the metal brackets I need for the rear lights, just don't want to order them and have hassle trying to make them fit as I read of possible issues with them but want to confirm.
Bumper Lamp Support Bracket Rear R/H for TOYOTA LAND CRUISER 3.0L Diesel - 3 door - 4/1996 to 7/2003 - [Leaving Land Cruiser Club]

 

[Beau]

I replaced mine without given they were half rusted. no problem

 

[Shayne]

I can only say the bolts of my cheap rubbish lights lined up correctly but the bulb holder mold meant i would have to trim the big holes in bumper lights slot into had i wanted them to be flush . Worst case scenario which i'm inclined to think you will avoid anyway is you might have to drill out the bolt holes bigger in the new back bracket .

 

[Beau]

The only thing I found with my replacement lights were the outer seal was more rigid than the OEM rubber which meant there was a slight 1mm gap around couple corners. Not enough to show but up close you could see.