Recovery points

[Springate’s]

I want to fit recovery points, any recommendations?
Seen these online: Roadsafe Recovery Points Toyota Land Cruiser Prado 150 155 Series 2010-on Rated Pair - 4x4 Works - [Leaving Land Cruiser Club]

https://www.4x4works.co.uk/product/...u02BX7aJ8XcWEKFY06dHhuuydxhtMIf0aAob3EALw_wcB

 

[SteveJB]

Just looked at the site they are Aus made and tested and if fitted and used as recommended should be no problem

 

[Springate’s]

Just looked at the site they are Aus made and tested and if fitted and used as recommended should be no problem

Cheers. Going to have a closer look at the fitting instructions before pulling the trigger-I’ve just had a new sump guard fitted.

 

[Springate’s]

Just looked at the site they are Aus made and tested and if fitted and used as recommended should be no problem

Unfortunately, they don’t have stock. The ARB model is available but requires some drilling and cutting to fit which is beyond my skill set!
Can’t find any UK manufacturers-money to be made!

 

[Springate’s]

Still no further in my quest for front recovery points…..
Also, now looking at what I believe is called a 2” receiver hitch for the rear. Plan is to use this for recovery and recovering not actually towing on the road so no need for electrics.
Any advice on a model which I can fit myself?
Presumably this cover on the rear bumper is removable?
Thanks

 

[Springate’s]

Finally removed the cover, basically stuck on with sealant, revealing a rough cut job. The top and bottom pair of holes are threaded.
To be honest I’m still very confused as to what I need in order to fit a 2” receiver hitch/tube. Any advice greatly appreciated!