Recent content by Aspire

Hi guys, Gearbox now swapped and running great, however I have now got an ignition problem when on gas or petrol when going up a hill the hot cat warning light flicks on . So the question is how do I check the advance ignition system or could it be anything else bering in mind it's been sat...

Gearbox code 63 defective solenoid 2 or circuit. Hi guys my new gearbox thrown up this error. Was working sluggish now no drive forward or reverse. The error code is showing this error. Where best to get a new solenoid? Cheers

Found it , not on wing or firewall. But on a wiring loom

Thanks will look for it when I'm home tonight

Hi Guys my new gearbox is flashing the overdrive light saying there is a fault So check the codes via the connector box which on lhd is on the passenger firewall. Bit where is it on RHD vehicles. Cheers

Any luck on your fix as a year on I'm in the same boat. Also where best to get a new gearbox from.

Do you know if these are easy to replace ?

Hi guys, Local garage Just changed autobox oil and filter on 4.5 petrol after they said that the box was low on fluid after its MOT so asked them to change oil and filter as it was a little black. Now only has reverse gear and no forward. Any ideas Thanks SIMON

That's what I would have thought but 1 have 5 wires for 4 connections....... and you could hear the relay clicking but seems now to have stopped. Also one of the red wires seems to have a constant feed so will double check the relay is fully home once I took it out. I BET someone changed the...

Hi guys it's been a while hope you are all ok. Need wine advice the horns have stopped working. The wiring to the horns is shot . I have 2 red and green wires next to a yellow and green coming fro the top and a red and green wires coming from the bottom. Has anyone got a picture of theirs as...

Thank you. Well I new my springs were worn . A 2 inch lift will give a ride height about 3.5 inches higher than present.

Hi guys. When measuring ride height to order new shocks and springs where does one measure to on the vehicle. And as the car is mainly used on the road and light cross country I am thinking of the peddlers set up. Thanks in advance Simon

I have an imported 4.5 as well I went the same way in that stainless front to back. Mone has 2 cats and 2 pre cat and 2 post cat sensors. The post cat sensors are discontinued. So may have to get mine re mapped or different configuration. If I am hijacking your post it is unintensional.

Good news Chris . My 80 has its mot on Friday last year it went through but the lambda sensors were just in. Trying to get new ones but mine has 4 2 pre and 2 post cats and the post cats are discontinued so if anyone has the post cats pm me. Just hope its the pre cats that are b*****d.

Hi guys. Truck sailed through mot but have noticed shocks n springs a bit on the tired side. Looking to exchange so do i keep the stock same hieght as looking like 1 inch lift or do i go for 2 inch. Truck used off road and towing horse trailer. What are peoples views / experienxe and hidden...