Couple of Qs
Front Bumper
After doing it, do you think the winch could go any higher and further back ?
Winch mount looks ~8mm plate with the rest looking like 2 or 3mm plate ('cept the mounts, onto them in a mo). The old Jeep plate was 6mm with just a bend, mounted direct to the top of the chassis I then had this (when I say I, I mean I had it done.... not welded anything since I was at school!) attached to the top of an existing bumper and added the gussets to attach to both mount points. I can see clearly where the bottom of the winch mount attaches to the chassis, is the top tied in as well or do you rely on the huge bar bolted at the bottom ? Can you get to the top to tie in top and bottom ?
Back Bumper
What does the receiver bar attach to if it's not the chassis rails ? or does the bumper attach to the body ?
Is it worth ataching to both as I plan to include a receiver in the bumper as well as recovery eyes?
Speaking of recovery eyes, you have done some welding around them, What did you do ?
this looks like mainly 2 or 3mm plate as well ?
Do you have any pics of the car with the bumpers removed ?
Thanks
EE