on a drive i went to down shift and suddenly couldnt get into any gear, i managed to get home by rev matching to change gear, i got hold of a new slave cylinder and have just installed and bled it this evening but still no change (i noticed fluid in the boot of the old slave cylinder when removing it) next step i guess is to change the master cylinder, then if not fixed take the transmission off and new clutch, i can see the clutch fork is moving an inch or slightly more when the pedal is pressed, could it be that it isnt bled properly and just needs that little bit extra travel? anything else i could look at before i get into taking it apart further, i hear there are two different kinds of clutches based on the flywheel if/when i get that far, or could the transmission be goosed?