cbv8
Member
- Joined
- Apr 25, 2017
- Messages
- 188
- Country Flag
Hi All,
I collected my new purchase today bought blind off eblag i know a thing you should never do but was quite a way from my house so asked as much as i could before purchasing anyway here we go. 1, The car has starting issues ie will turn over about 20 times on the key until it fires it has has new glow plugs and there is power getting to them? 2,On the 90 mile journey back the temperature gauge hovered between the lower end of the gauge when driving around 40mph and then rises to almost the middle of the gauge at 70+ but never higher is this normal i checked the coolant which was up to the level? 3, I noticed the kickdown cable was stuck out on the throttle cam after spraying the cable end with wd 40 it has freed off how do i adjust the cable should the crimped bit stop on the threaded end or should there be a gap? i then checked the trans fluid which is a dark grey colour it didnt smell burnt just oily if that makes sense
just hope it has no cooked the box
And finally the steering wheel is off centre to the left and pulls to the right all the tyres are nearly new except the ofs front the ride was figity which i hope is down to tyre pressures being too high other than these faults/niggles the car drove great with no smoke or loss of power any help or advice very very much appreciated 

I collected my new purchase today bought blind off eblag i know a thing you should never do but was quite a way from my house so asked as much as i could before purchasing anyway here we go. 1, The car has starting issues ie will turn over about 20 times on the key until it fires it has has new glow plugs and there is power getting to them? 2,On the 90 mile journey back the temperature gauge hovered between the lower end of the gauge when driving around 40mph and then rises to almost the middle of the gauge at 70+ but never higher is this normal i checked the coolant which was up to the level? 3, I noticed the kickdown cable was stuck out on the throttle cam after spraying the cable end with wd 40 it has freed off how do i adjust the cable should the crimped bit stop on the threaded end or should there be a gap? i then checked the trans fluid which is a dark grey colour it didnt smell burnt just oily if that makes sense


