Glad I got the seller to renew the MOT when I bought it. Reasons for failure......
Nearside Front position lamp(s) not working (1.1.A.2b)
Offside Front position lamp(s) not working (1.1.A.2b)
Offside dip beam Headlamp not in good working order adversely affecting beam image (1.2.4a)
Offside main beam Headlamp aim too low and too far to the right. (1.8)
Windscreen washer provides insufficient washer liquid (8.2.3)
Both Windscreen wiper does not clear the windscreen effectively (8.2.2)
Nearside Front wheel bearing has excessive play (2.5.A.3c)
Offside Front wheel bearing has excessive play (2.5.A.3c)
Offside Rear Brake disc(s) excessively scored (3.5.1h)
Steering column shaft Steering system fouling (2.2.D.2a)
Offside Rear Brake pipe excessively corroded (3.6.B.2c)
Nearside Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1f)
Front to rear Brake pipe inadequately clipped (3.6.B.1)
Offside Front Brake pipe excessively corroded (3.6.B.2c)
Offside Front Brake hose excessively deteriorated (3.6.B.4d) **DANGEROUS**
Nearside Rear Brake pipe inadequately clipped (3.6.B.1)
Rear tail pipe Exhaust has a part missing (7.1.1a)
Front flange Exhaust has a major leak of exhaust gases (7.1.2a)
Rear Exhaust has part of the system excessively deteriorated (7.1.1a)
Handbrake cable Brake pivot has restricted free movement (3.5.1j)
Offside Rear Anti-roll bar linkage inadequately repaired (2.4.G.1)
OSF brake hose split Brake performance not tested (3.7)
Service brake efficiency below requirements (3.7.A.9)
Parking brake efficiency below requirements (3.7.A.10)