So I started my packing systemdesign today, with Google Sketchup. What a pain to design it - but I think I've got the basics of the frame done:
Getting the angles at the back for the seat-backs was a bit awkward ...
I can't afford the fancy Platinum drop-down fridge slider, so I'll get the Waeco one, which wil go in the 'box' on the left. SWMBO's a porg, so it has to go down low unless I carry a foot-stool for her, and that's not going to happen! The vehicle still has to go up another 60mm ....
On the right will be two drawers approx 850mm deep, with tie-downs on top for other 'stuff' ...
Not sure whether to hinge the wings or leave them as shelves. And I haven't decided whether to close them off at the front and rear either ... Decisions, decisions ...
Will update as I go along. Behind the packing frame will be the Dog Guard, which I installed this afternoon ...
Getting the angles at the back for the seat-backs was a bit awkward ...
I can't afford the fancy Platinum drop-down fridge slider, so I'll get the Waeco one, which wil go in the 'box' on the left. SWMBO's a porg, so it has to go down low unless I carry a foot-stool for her, and that's not going to happen! The vehicle still has to go up another 60mm ....
On the right will be two drawers approx 850mm deep, with tie-downs on top for other 'stuff' ...
Not sure whether to hinge the wings or leave them as shelves. And I haven't decided whether to close them off at the front and rear either ... Decisions, decisions ...
Will update as I go along. Behind the packing frame will be the Dog Guard, which I installed this afternoon ...